Hi all,
I am working within the fluid-structure interaction module in COMSOL. I would like to vary one of my geometric parameters to optimize a design, and as you all know, COMSOL with MATLAB is the best place to do this. My problem is this, specifically:
When I 'Save as Model-M File' and open up that file in MATLAB, much to my surprise I find all my parameters to be different than what I have saved in my original COMSOL file! This is not limited to different fluid velocities at the inlet, but also inclues completely altering my geometry that I have specified in the original model.
Does anyone have any inkling as to why COMSOL is doing this? It is obviously very frustrating, and I am pretty new with the interface so I am lost as to what is happening here.
Thanks for your help!
I am working within the fluid-structure interaction module in COMSOL. I would like to vary one of my geometric parameters to optimize a design, and as you all know, COMSOL with MATLAB is the best place to do this. My problem is this, specifically:
When I 'Save as Model-M File' and open up that file in MATLAB, much to my surprise I find all my parameters to be different than what I have saved in my original COMSOL file! This is not limited to different fluid velocities at the inlet, but also inclues completely altering my geometry that I have specified in the original model.
Does anyone have any inkling as to why COMSOL is doing this? It is obviously very frustrating, and I am pretty new with the interface so I am lost as to what is happening here.
Thanks for your help!